Arcade monitor vs tv

April 17,AM Welcome, Guest. Please login or register. Glad you made it! Newbie Offline Posts: 9. Arcade Monitor vs TV. Hello all! The systems are identical andjavascript:void 0 ; Neo Geo was advertised as bringing pixel perfect arcade experience to your living room. However, I noticed the quality of the picture itself was less than impressive. What could cause this? Is there a difference in quality between a home TV and a monitor such as a Wells Gardner featured in an arcade cabinet?

Newbie Offline Posts: Re: Arcade Monitor vs TV. I have one too. Arcade monitors often have better resolution, but look at the connection to the TV your console uses. I bet it's composite like mine which gets the job done but is a low quality video signal compared to what we use today i think the best it can do is i? Awhile ago I saw people who would offer to mod the Neo Geo AES to give it an S-video connection which was slightly better and it wouldn't surprise me if they would be offering HDMI modding services now although I haven't looked.

The TV should be similar in quality to an arcade monitor although the quality of the components will vary between manufacturers. The problem is the if you are using a composite yellow cable to connect to the TV.

In an arcade machine, the arcade game pcb outputs an RGB on three separate wires. One for Red, one for Green and one for Blue. These three wires plus the separate sync wires are sent separately and connect to the arcade monitor directly so no drop in signal quality.

A composite signal has to send all three colours plus the sync signals along one wire meaning that you lose a lot of information and therefore quality. S-Video is slightly better because it splits some of the composite signal into another wire but all colours still get sent on the same wire within the s-video cable. Alternatively old broadcast monitors usually accept an RGB signal. Powered by SMF 1.What monitor you need for your arcade game, what resolution, how to hook it up.

You will find out all that information and more here. Register now to be part of ArcadeMonitor. An arcade monitor does not hook up like a TV its more like a computer monitor. Most early arcade games before they started using VGA cables were hooked up with the red, green, blue, sync, and ground wires from the game. This is why arcade games look so much better then home systems back then.

arcade monitor vs tv

The red, green, and blue wires are the signals for the red, green, and blue electron beams in the CRT monitor. Most new arcade monitors all use VGA now but the one thing that really set them apart from your computer monitor and TV is they are designed with a frame for installing them in an arcade cabinet!

This is a good thing because it really is the best way to mount the monitor in the cabinet. If you try to put a computer monitor in and arcade game their is no way to bolt the thing in, so it can move around.

Pin Up Casino??? Click wisely, and get paid for it 0. Sick of technical barriers… the solution 0. Help identifying a Wells Gardner Model Need to replace the flyback 3. Bitcoin Wallet Hack Download 0. NeoTec NT Medium resolution arcade monitor making a clicking sound.

arcade monitor vs tv

Wells Gardner D with a vertical deflection problem. Installing a cap kit on a Wells Gardner K arcade monitor. Arcade Monitors for Sale. Monitor Repair. Sign in. Featured Products. Everything you need to know about the arcade monitor. Buy Arcade Monitors Here! View Forum Pin Up Casino???In other words I play the games exactly at the same resolution supposed by the programmers during the code development. I can already say that the difference in video quality between a game played on CRT monitor or LCD monitor is quite an abyss.

The camera is not capable to show what the eyes are able to see and I confirm that the difference is greater than the one shown in the photos. I used one of my favourite arcade games during the test: Metal Slug. As the photos show, the colors and the details of Metal Slug displayed on CRT television are the best. Thus, the video at xpx must be scaled at the resolution of the LCD display. This type of video converters uses an Analog to Digital Converter ADC to digitize the video, so thanks to an image processing IC it scales upscales the video and then the digital samples are converted in analog with an Digital to Analog Converter DAC.

With this type of conversion, the original video signals are only a memory. I think you mixed up pictures. The image above is inferior to the bottom which are lcd according to you. If this is true than lcd better? Your email address will not be published. Italiano IT. ACE Innovation.

Search for:. Share this content Twitter. January 9 at PM. Alessio says:. Leave a Reply Cancel reply Your email address will not be published.

Next Post. Previous Post. Get in touch info aceinnova. Newsletter Sign-up.By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. Retrocomputing Stack Exchange is a question and answer site for vintage-computer hobbyists interested in restoring, preserving, and using the classic computer and gaming systems of yesteryear.

It only takes a minute to sign up. It is well known that when emulating classic games on modern displays, you need to be careful not to distort the aspect ratio. Generally speaking, CRT screens wereand specific pixel aspect ratios of many classic arcade games, consoles and computers are given here. Of course, title safe area was a concern, particularly for home computers that had to work on many different models of TV sets.

It's hard to say exactly what was the title safe area for NTSC TV, but the Commodore 64 is generally accepted as having come pretty close to it. That is significantly past the title safe area and into overscan, but that's fine, that was a feature for a dedicated console; it matches one's memory of playing Super Mario Brothers, where objects would scroll onto the right of the screen without any visible border. That is even considerably further into overscan.

Resources are being wasted generating pixels the player will never see That's an arcade machine. It came with its own screen. Sure, TV picture tube minus the tuner, overall aspect ratio. But maybe they could have tweaked the display electronics to shrink the horizontal scan, so more of that But in that case, the calculated pixel aspect ratio of would be no longer valid.

And in general, it would be harder to figure out exactly what was the pixel aspect ratio of arcade machines. Calculating it from the pixel clock in the same way as for home computers and consoles would no longer give quite the correct results.

Slashdot Top Deals

Is the above conjecture correct? Or did arcade machines actually use the same parameters as TV sets, and did Missile Command just accept some extra wasted pixels? CRTs don't have pixels, they don't work that way. Also, arcade monitors expose all the picture controls at the back so it is possible to adjust them quite extensively.

Modifying A CRT Television For Use As An Arcade Monitor

Operators would have made sure that the picture was the right shape and in focus near the edges. Since the controls are all analogue and no-one bothered to measure the display geometry the aspect ratio was just close tobasically whatever looked good to whoever set it up. The picture controls adjust the width of the beam scanning area, for example, so the pixel clock is irrelevant.

The owner just turns the knob until the picture covers most of the screen. Games were designed with this in mind and the horizontal resolution was just that - resolution, not an attempt to create a particular aspect ratio. In the upper right there is a zoomed in area from Sonic's foot, which shows some of the vertical bars that people often assume are pixels are in fact not evenly lit. The tops and bottoms of some of them are at different brightness levels.

The bars you can see are actually the shadow mask, and are unrelated to pixels. They define the maximum horizontal resolution that the CRT is capable of resolving, but even then the relationship is not To start with, 'Title Safe Area' is an idea to define the parts of one transmission to be displayed even if any of the many receivers is maladjusted.

It's nothing inherent to the TV signal or its definition, it's a safeguard against less than correct receivers. Next, Pixel ratio is, even on a TV, complete arbitrary.

TV sets a frame timing, but not a pixel one. The number frames per second and number of lines within a frame is defined by the respective standard, but that's it.

arcade monitor vs tv

The number of pixels per line is, even on TV, infinite. Of course, as they get defined 'tighter', as more restrictions due transmission and electronics appear. It's up to the application what restrictions are acceptable or not.I own a "Raiden" stand-up cabinet, and have for several years. I while back, the video went out game still plays, everything else works, just nothing on the screen. At first, I figured I would just 'unload' the entire cabinet in a non-functioning state to my closest game room or arcade dealer.

However, I would actually prefer to just fix the video and have it up and running in the garage again. Do I need to buy a special monitor for it, or is it possible for your basic geek to hook up an old PC monitor or television to accept the output from the game? If it costs several hundred dollars, then I don't want to keep the game.

However, if I can do this on the cheap, I want a video game in my garage again. Thoughts, suggestions, experiences?

Everything you need to know about the arcade monitor.

I'm not an arcade tech, but I'm fairly sure that most arcade machine screens are just your run of the mill crt. That said, you can't just shove a TV in there. You could probably have your machine checked out by a local shop for free or a small fee. Generally they can repair the monitor rather than replace it. Also, you're a bastard. I wish I owned a Raiden, it's one of my favorite games. I'm giving away my R-Type cab because of the poor shape it's in, though I'm keeping the game board in hopes it's not shot.

Not sure how differently a production made box is but I can't imagine its that different Link for the monitor section: here or you could try a place like arcadecontrols. Ok, first off, you can't just jam any old CRT in there, no. Get into the cab and find the model and anything else that might help first. Now Raiden is a JAMMA title, and it's likely that what you own is a converted cabinet, so your monitor could be quite a lot older than 17 years potentially.The image above shows him testing a Pac-Man machine on the altered Sharp television.

Those familiar with the game will immediately notice that there is something wrong. We see most of the tracks upon which Pac-Man and the ghosts travel, but he maze itself is completely missing. To get to this point [Eric] consulted the television and arcade schematics to figure out how to connect the composite sync and three color channels directly to the arcade machine. This way the CRT timing is forced to conform to the game standard. The problem is that there is no way to adjust the drive and cutoff of the individual color channels.

This is something [Eric] hopes to fix in the next iteration of his experiments. If you already have a working arcade monitor but no gaming cabinet why not use a Raspberry Pi? He can also use a scan converter as well. In my opinion, the tubes on a decent 15khz Sony trinitron tv are superior to what you find in your average crt arcade monitor anyway. While the image looks a little different, with the right connection and source, the image is not worse.

Also, it is far easier and cheaper to find a decent sized crt tv than it is to find a working arcade monitor without screen burn. Those things were used to death and they are becoming rare and expensive. Advanced users can attach a real arcade input board if they want to go the extra mile but component is hard to distinguish from rgb for the average user.

I would also point out that not all rgb or component images look the same. A component connection on a superior tv with a quality source and cable, can look better than an rgb image on an inferior set-up.

The rgb image on my first scart tv looked horrible and inferior to the image I get through s-video on my current one. Street fighter 2 and final fight look better running off the original jamma pcb on my Sony trinitron than they ever looked in my local arcade.

The extron converts vga to i and outputs s-video. The 15khz i image is massively superior to the p image on my crt vga monitor at hz and better than anything I could get on my lcd monitor. For most people, this is the easiest and cheapest way to play old arcade games on a 15khz tv.

Those old broadcast quality scan converters are not hard to find used and they are very cheap. Using mame on my p lcd monitor was never good enough for me, no matter what HLSL settings I used. I am not sure what problem this hack solves but I think you were beaten by at least 20 years. Super guns were never expensive and they are easily available new on ebay even today. Also, people who have a Nintendo wii can play emulated classic games at their original resolutions which may be the easiest although not the cheapest option for some people.

If you run a pc monitor or lcd on a real arcade pcb, the higher dot pitch makes the games look terrible. That being said, there are simplier ways to fix his issue. The most popular one is to simply buy an arcade chassis specifically designed for old tv tubes. Doable, but a PITA. Unburned arcade CRTs are getting harder to come by. The thick red wire that goes to the screen is normally 12, Volts to 26, Volts depending on the screen size. The screen is like a big capacitor and this voltage will remain for some time after power is disconnected, it has to be discharged.

Impedance is magic, so standard practice when swapping tubes is to use the resistance of the X and Y yokes as a ballpark substitute. If the monitor chassis is built to drive a yoke whose X and Y coils have resistances of 2.In this day and age however, one can now be substituted for the other with little to no effort, thanks to our fast-advancing technology.

So if you are thinking of doing so, you might want to learn the differences between the two to avoid issues and disappointments. Computer Monitor — Also known as a computer display, a computer monitor is the electronic visual display for PC systems. It comprises of a power supply, casing, circuitry and of course, the display device. There are a few common aspect ratios or geometric shape of a computer display, and these are, and TV — commonly known as the telly, the tube, or simply TV, is a telecommunication medium used to transmit a moving image and sound.

It is a mass medium worldwide for news, education, and entertainment. TV started as a mechanical television, advanced through electronics, upgraded to a color television, advanced once more to digital television, and now we have our 3d and smart televisions.

It also underwent four broadcast systems and started from terrestrial television that used antennas, then moved on to cable television, satellite television, and eventually internet television.

The TV system started as a Disk that used a spinning disk to create and reproduce images that had low resolution and screen size. Now that both units are usually interchangeable, it all comes down to their pricing, resolutions, input connectors, speakers, and their sizes. A computer monitor tends to have a higher resolution than most TVs at its own price.

Compare an Acer RHY for example, A TV has more input connectors than a monitor though, and it also has a built-in speaker rather than a separate device when using a computer. So depending on the technology used on each one of them, the difference mainly lies on the pricing, the speaker and built-in TV tuner. About us Contact. Difference between a Computer Monitor and a TV.

Updated on February 23, Did this article help you? Yes No. Current rating: 5. The facts are wrong. Article needs more images. Article is outdated. Too general - need more details. Something else. Send Cancel. All rights reserved.

Please read the Terms of Use and Privacy Policy. Copying is allowed with active link to TheyDiffer. Privacy Policy Terms of Use Contact.


0 thoughts on “Arcade monitor vs tv

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes:

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>